|
|
 |
|
|
|
 |
| |
Detel Dual 29
An ideal solution for manufacturers using KD fittings. The machine has two heads each with 29 spindles.
The vertical head, which drills from the bottom upwards and the horizontal head operate in sequence, to ensure the drills will not collide. The horizontal head can be excluded for vertical (face) drilling only. |
|
|
|
|
| |
The machine is supplied with a complete set of fences and stops to offer full flexibility and fast set up times. With a cycle time for both vertical and face drilling of around ten seconds and the need to only handle panels once, this machine can provide a considerable improvement in throughput in comparison to a single headed machine.
Detel Linear 42
Two vertical drill blocks of 21 spindles make this operation fast and accurate. As both sets of holes are drilled simultaneously from the same datum accuracy is assured and cycle times reduced. The 3m fence will allow drilling of wardrobe or larder units whilst the reiteration stop ensures consistency of hole centres regardless of the number of repetitions required. Either head can be excluded to allow the machine to be used for alternative face drilling operations. |
|
|
|
 |
|
 |
| |
| Detel Model |
Dual 29 |
Linear 42 |
| No. of spindles |
2 x 29 |
2 x 21 |
|
| Pneumatic clamps |
3 |
2 |
|
| Drilling cycle |
Sequential |
Simultaneous |
|
| Power / air |
3 phase / 7 bar |
3 phase / 7 bar |
|
|
|
 |
|
 |
|
|
|
|
|
|
| |
Detel Prima 63
The Detel Prima 63 is equipped with one horizontal and two vertical boring groups. All three have 21 quick release spindles at 32mm centres
The longitudinal displacement of the groups is achieved on two round bars and two vertical support rails which guarantee the vertical alignment of each group.
The movement is by individual lead screws with the position shown on digital readouts at the end of the machine.
Each boring group has two large round guide bars to guarantee the precise horizontal movement and a separate depth control to drill to a maximum depth of 90mm with pneumatic feed speed regulation for optimum cutting speeds and cycle time.
The operation of the spindles and movement of the horizontal and vertical boring groups are controlled by a footpedal. This enables all boring operations to be activated by one press of the pedal. |
|
|
|
|
|
|
| |
| Detel Model |
Detel Prima 63 |
| No. of spindles |
3 x 21 |
|
| Centre distance between spindles |
32mm |
|
| Max. distance between spindles |
640mm |
|
| Maximum drilling depth |
90mm |
|
| Min. distance between vertical groups |
128mm |
|
| Max. distance between vertical groups |
1008mm |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
©
Ney Ltd, All Rights Reserved |
|
|
|
|
|
|
