| |
The glue pot has pneumatically controlled gates which automatically close when the machine is switched off to prevent glue spillage. It is also equipped with a glue scraper mechanism inside the glue pot to prevent glue oxidisation and keep the warm up time to a minimum.
Automatic tape infeed via solenoid and timer with easy external adjustment for tape infeed length, ensures that the tape is in the correct position to receive the panel with the minimum of tape wastage.
The infeed fence is fully adjustable to accommodate thicker edgebanding materials, with the measurement shown on digital readouts. The first silicon pressure roller can be left fixed for maximum bond on thin coil material or spring loaded for thicker materials.
Automatic board transportation is via a centrally adjustable pressure beam, which gives a constant through feed speed of 10 m/min and a constant side pressure to give a consistent quality of bond and trim. |
|
Equipped with electro-pneumatic pre-cutting guillotine to cut material up to 3mm thick directly from the coil.
Front and rear end trim via one 0.5 HP high frequency motor running at 12000 rpm, for the flush trimming of the front and rear ends of a panel edged with material up to 3mm thick.
Top and bottom trimming via two 0.5HP high frequency motors running at 12000 rpm. Each motor is inclinable from 0 - 30º and is equipped with a milling block with 4, two sided 3mm combination cutter tips. Each motor is laterally adjustable on a digital readout to use the full width of the cutter and extend the working life of each tip and give low replacement cutter costs. Easy adjustment of the vertical tracers gives very accurate trim and fast setting times for different types and thickness of edging materials. The top trimming motor is attached to the top pressure beam and is automatically adjusted for different thickness of panel with no need for any separate trim adjustment. |
